Paslode 902400 Use and Care Manual

19IMPORTANT!DO NOT DESTROYIt is the customer's responsibility to have all operators and service personnel read and understand this manual.OPERATI

9 DANGERE X P L O S I O N/F I R E HAZARD WARNINGSunlight can raise the inside temperature of an unventilated car or van to a

10Fuel Cartridge NOTE:Paslode Cordless fuel cartridges are marked with a “Best Use Before” date on the bottom of the can.For maximum performance use f

11Inserting Fuel Cartridge➔1. PRESS UP➔1. Close over2. PULL OUT➔2. PRESS DOWN ➔ Fuel CartridgeB. Lift the fuel cartridge adaptor an

12Paslode Cordless 16 ga. Angled yrd ni ,sroodtuo reliaN hsiniF sseldroC eht esUweather, when the nailer, fuel cartridge and battery are between 20°

13Paslode Cordless 16 ga. Angled Depth of Drive AdjustmentRemove the battery before adjusting the depth of drive.The depth of drive adjustment is

14Fasteners and ApplicationsApplicationsThe Paslode Cordless 16 ga. Angled Finish Nailer is suited for a variety of applications. These include secur

15Restrict Field Service to the Following RECHARGING THE BATTERY CHECKING THE FUEL CARTRIDGE REPLACING THE FUEL CARTRIDGE CLEANING/REPLACING T

16ServicingAir FilterOpen the grille by pressing slightly above the adapter and pivoting the cover open. The air filter simply lifts out. naelc dna kc

17Battery does not appear to accept charge when battery is plugged into the charger.Charger gets hot, makes excessively loud noise, or smokes during c

18Tool operates properly, but fasteners do not drive fully.Tool operates properly, but fasteners are sometimes over-driven, and sometimes under-driven

1ContentsSubject PageIntroduction and Warranty ...

2Introduction and WarrantyFor ease of use, this manual is divided into sections (see Contents). Each section of the manual is written with you, the to

3DescriptionIn order for you to fully understand the information contained in this manual, you need a basic understanding of the Cordless Fin

4Safety Instructions DANGER WARNING WARNINGDo not expose the tool to temperatures in excess of 120° F (49° C). Fuel and/

5Safety Instructions WARNING7. NEVER OPERATE THE TOOL WITH THE WORK CONTACTING ELEMENT REMOVED OR DISABLED. This device helps r

6Safety Instructions12. NEVER DRIVE FASTENERS INTO AREAS WITH CONCEALED HAZARDS. Always check the area behind the work surface for elect

7WarningCHEMICAL/EXPLOSIONHAZARDRead ALL instructions be-fore charging or using bat-tery. Failure to follow ALL instructions may result in fire, se

8Battery and Charging SystemInserting Battery1. hsiniF sseldroC eht otni ,tsrfi stcatnoc ,yrettab eht daoLNailer.2. Push battery fully forward int