Paslode 902000 Use and Care Manual

Cleaning ProcedureCordless 16 GaugeStraight Finish NailerPart No. 902000Cordless 18 GaugeBrad NailerPart No. 90100016 and 18 GAUGE CORDLESSFINISH NAIL

10CombustionChamber(Cámara decombustíon)Sleeve (Cilindro)Piston (Píston)Motor AssemblyConjunto del Motor DANGERDo not attempt to operate the tool unl

11The maintenance interval for cleaning the PaslodeCordless Finish Nailer will vary depending uponthe number of nails driven per week, and theoperatin

An Illinois Tool Works Company888 Forest Edge DriveVernon Hills, Illinois 60061www.paslode.comPrinted in U.S.A.©2007, Illinois Tool Works, Inc.902019-

2Step 1Using the 9/64" Hex Key (#900736), unscrew four#8-32 x 1-1/4" long Socket Head Cap Screws from theCap Assembly. Leave the screws i

3Step 2Remove the Cap, Filter, and Grill as one assembly, andset aside. The Filter may be removed by lifting the Grilloff the Cap. Clean the Filter wi

4Step 4Rotate the Cylinder Head Assembly counterclockwise 1/8 of a turn and lift the cylinder headfrom the Motor Assembly.Paso 4Haga girar el conjunto

5Step 6Spray the Cylinder Head with Degreaser Cleaner. Allowthe dirt and debris to drip off.Paso 6Aplique limpiador de seguridad a la tapa del cilind

6Step 8Lightly lubricate the Seal Rings with 4-5 drops ofPaslode Cordless Lubricating Oil, part #401482.Make sure oil is applied evenly around the Sea

7Step 10Spray a liberal amount of Degreaser Cleaner into theinside of the Sleeve and Combustion Chamber.Invert the Motor Assembly, and let excess cle

8Step 12With Motor Assembly tilted up, squeeze 3-4 drops ofPaslode Cordless Lubricating Oil into Sleeve (Area"A") and 4-5 drops onto lower l

9Step 14Manually push the Driver Blade up and down todistribute the oil in the Sleeve evenly.Reassemble the Paslode Cordless Finish Nailerfollowing di